The site navigation utilizes arrow, enter, escape, and space bar key commands. Left and right arrows move across top level links and expand / close menus in sub levels. Up and Down arrows will open main level menus and toggle through sub tier links. Enter and space open menus and escape closes them as well. Tab will move on to the next part of the site rather than go through menu items.

News

OSHA Requests Information on Possible Updates to Lockout/Tagout Standard

May 20, 2019

osha-small The U.S. Department of Labor’s Occupational Safety and Health Administration (OSHA) requested information on a possible update to the Control of Hazardous Energy (Lockout/Tagout (LOTO)) standard.

In a press release sent out on May 17, the agency said it is interested in comments on the use of control circuit-type devices to isolate energy, as well as the evolving technology for robotics.

OSHA seeks information about how employers have been using control circuit devices, including information about the types of circuitry and safety procedures being used; limitations of their use, to determine under what other conditions control circuit-type devices could be used safely; new risks of worker exposure to hazardous energy as a result of increased interaction with robots; and whether the agency should consider changes to the LOTO standard that would address these new risks.

The current LOTO standard, which was published in 1989, requires that all sources of energy be controlled during servicing and maintenance of machines and equipment using an energy-isolating device. The standard specifies that control circuit devices cannot be used as energy-isolating devices, but the agency recognizes recent technological advances may have improved the safety of control circuit-type devices.

Comments must be submitted on or before Aug. 18. Comments and materials may be submitted electronically at http://www.regulations.gov, the Federal e-Rulemaking Portal, or by facsimile or mail. See the Federal Register notice for submission details.